A true three dimensional form fitting glove with curved finger design, inset thumb with enhanced finger dexterity.

The one piece back shell is made from 100% Kevlar® knit fleece 7.5 oz. FR and water repellent fabric with exceptional flexibility across back of hand. A non-restricting Eversoft® knuckle band sewn across back for added knuckle protection. Elastic sewn into wrist crease for close fitting cuff.

Back is lined with a layer of 6 oz. modacrylic non-melting and non-dripping liner.

A double backed 3 mil breathable Pryotect Barricade moisture barrier 100 % water proof, viral/chemical penetration resistant, and provides blood borne pathogen protection. Barrier extends full length of glove for complete protection.

The 6 oz . 65% Kevlar® and 35% Nomex® stitch bond FR liner lines the inside back of hand.

Five separate finger fochettes curved and form fitted cut from 3.5 oz. to 4 oz. black flexor cowhide tanned to meet NFPA flame test for the highest finger dexterity.

Special breathable adhesive is coated over entire finger, thumb and palm area, ensuring full liner/barrier/glove adhesion meets NFPA requirements for liner retention.

Palm is 1 pc. 3.50 to 4.0 oz. Eversoft® cow leather tanned to meet NFPA flame resistance test and tanned with additives to stay soft when wet and low water absorbance with repeated soakings. Thumb is 2 pc. inset into palm to provide unrestricted movements of the thumb right to left.

Glove liner has a 2 inch grain leather cuff sewn inside glove wrist over top of the liner for the gauntlet model and bond with 1 1/2 inch black FR binding to finish cuff.

Wristlet model has a 4” Black Nomex® cuff with leather pull patch and hang up loop.

This glove is sewn completely with 30/3 Kevlar® thread.

This glove is NFPA 1971-2013 by the Safety Equipment Institute (SEI).

• 60+ TPP and class leading Conductive Heat transfer protection.
• 100% Kevlar knit fleece FR water repellent with 1 Pc. back shell.
•  Layered non-restrictive knuckle patch.
• Extra layer of 6 oz. modacrylic liner sewn to the back shell.
• A double backed 3 mil breathable Pyrotect Barricade moisture barrier.
• 100% water proof, viral/chemical penetration and blood borne pathogen protection.
• A layered 6 oz. 65% Kevlar/35% Nomex stitch bond FR liner.
• Five separate curved form fitting forchettes from 3.5 oz. to 4.0 oz. grain cow leather for maximum finger dexterity with a 60+ PPT rating.
• Exclusive breathable adhesive for ensuring full liner/barrier glove bonding.
• 1 piece palm 3.50 oz. to 4.0 oz. Eversoft® cow leather tanned with additives to stay soft when wet and low water absorbance with repeated soakings with a 60+ TPP rating.
• 4” Black nomex cuff with leather pull patch and hang up loop.
• This glove is proudly made in the USA with highly skilled employees.
• This glove is certified to NFPA 1971-2013 by the Safety Equipment Institute (SEI).